Home Page | Forum | Downloads | About us | Services | Products | Online Portal | Site Map | Contact Us

motorola
August 25, 2019, 08:47:42 PM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News:
 
   Home   Help Contact Admin Team Search Login Register  

Radio Services

Supply Radios, Spare Parts, Programming Cables, Flash Adapters

Members area provides radio programming videos

If we have helped you, please make a donation, however small. This helps us develop the site and offer better services.

Advert

Pages: [1]   Go Down
  Print  
Author Topic: GM950 TX Problem (Flashing LED's and Intermittant Bleeps) RX OK <HELP>  (Read 3184 times)
0 Members and 1 Guest are viewing this topic.
g1ivg
Basic Account


FeedBack +0/-0
Offline Offline

Posts: 1


« on: May 23, 2015, 12:02:33 PM »

Help!!!

I have a GM950 (VHF) model M08KHF4AN3AN that has developed a fault.  RX is fine, but when I press the PTT I get no RF out and the LED's on the left of the display flash and the radio emits a intermittent bleep as can be see in the video here:

 http://www.g1ivg.com/photos/GM950_TX_Error.MOV

I have tried reprogramming the radio on various frequencies throughout it's VHF range, but it still has this issue.  Currently its programmed on the amateur 2m band and RX is very good, but I have no RF power going out when I press the PTT.

Any help or advice most welcome.

73 Colin G1IVG
Logged
zenbaki
Basic Account


FeedBack +1/-0
Offline Offline

Posts: 1


« Reply #1 on: February 04, 2019, 09:16:22 PM »

Hello Colin,

I know that this is an old entry, but since it is the same fault and I have not found information about it, I consult you if you have managed to solve the problem.

I bring my experience:
As you read on page 3 of https://www.zenbakaitz.com/GM950_UG_EN.pdf, I understand that the failure is due to the hardware:
Audio Signals

H / W error - Button press
not accepted, tone
continue until valid
operation.


I have:
* Disconnected the RF exciter and amplifier stages
* Disconnected the temperature sensor of the RF amplifier stage, the NTC R3611 (THERM 100K @ 25C)
* Changed the voltage regulator U0601 (IC 9.3V REG 2941)
* Changed the head of the radio
* Made many changes in its programming (frequencies, powers, etc.)

I would try to update the firmware, but I have not found enough information to do it. Here it says that it is possible to do it:
http://agh-technik.orgfree.com/motofunk.html#GM950

I only conclude that the fault is located on the main board of the radio, but I do not know if it is hardware or software still.
It could also be a damaged internal track, since it is a multilayer plate.

A cordial greeting.
Josť Luis
LU6ENY
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  

Home    Forum | Downloads | About us | Services  | Products | Online Portal | Site Map | Contact Us

© Copyright 2008-2010 Motorola Radio Support Group. All Rights Reserved.

Google PageRank
Powered by MySQL Powered by PHP Powered by SMF 1.1.18 | SMF © 2013, Simple Machines | Sitemap Valid XHTML 1.0! Valid CSS!
Page created in 0.034 seconds with 22 queries.

Google visited last this page August 11, 2019, 04:35:35 AM