MTM800E in program mode ???

[AHO]

Hello

Can anyone tell med how to put the MTM800E in program mode,
i´ve got the software and the cable ,
but can´t get it in program mode.

I´ve tryed with 1+9+PWR like a MTP850,
but it does not work ?

Thanks

Allan

[RIZALDI]

1. Press 1 + 9 + On/Off Button at your radio
2. Hold it for several seconds
3. Scan usable Com Port from communication settings
4. Pick your desired Com port, or which one you want to read. The Display or Transceiver box.
5. if still doesn't work, try to install USB Driver from the installer package

[radiobup]

Hi,

From CPS Start-up User Guide:

PROGRAMMING MTM800 WITH SERIAL PORT CABLE
To perform the programming, proceed as follows:

1. Power OFF the terminal.

2. Connect the programming cable (USB - 3071810M01, or Standard RS232
cable). The programming cable interfaces between the mobile terminal and
an IBM PC (or compatible computer) running on the TETRA CPS. If a
standard control head is attached, switch ON the terminal.

3. In the case of a motorcycle model, remove the control head from the 25-pin
connector of the expansion head and treat like expansion head only. The
terminal screen remains dark. If your terminal has only an expansion head
without any control head connect pin 6 to pin 14 on the 25-pin connector on
the expansion head front to switch ON the terminal and to enter programming
mode.

4. Run the Customer Programming Software (CPS) on your computer.

5. Select Tools > Options. Change the Communication setting according to the
computer serial port you are using for the programming cable.

6. Start desired CPS operation. For example, select File > Read Phone. The
terminal screen stays dark.

7. Follow the instructions on your PC.